![]() ![]() There's a HID device and that UPS that show up correctly because they get picked up and identified. If you are installing Windows 10 on a PC running Windows XP or Windows Vista, or if you need to create installation media to install Windows 10 on a different PC, see Using the tool to create installation media (USB flash drive, DVD, or ISO file) to install Windows 10 on a different PC section below. It's possible that usb 2-10 there might be the scanner, but lsusb doesn't see it and it doesn't respond the way xchi/ehci expects for some reason. several of my computers are on UPS so I can keep working through a power outage for about 48 minutes or safely power down equipment that shouldn't just get switched off, so many of them have a USB interface to the UPS to communicate with it about how severe the situation is:įeb 22 17:53:10 post kernel: usb 2-4: new low-speed USB device number 57 using xhci_hcdįeb 22 17:53:10 post kernel: usb 2-4: New USB device strings: Mfr=1, Product=2, SerialNumber=0įeb 22 17:53:10 post kernel: usb 2-4: Manufacturer: Tripp Liteįeb 22 17:53:10 post kernel: hid-generic 0003:09AE:2012.0563: hiddev0,hidraw0: USB HID v1.10 Device on usb-0000:00:14.0-4/input0įeb 22 17:55:05 post kernel: usb 2-10: new full-speed USB device number 60 using xhci_hcdįeb 22 17:55:05 post kernel: usb 2-10: Device not responding to setup address. As devices are attached/removed they are detected and identified e.g. Click on the Trunked Radio Systems Tab Click on the Site you wish to enter the custom tables. ![]() It charges over USB but it does not register on the bus. iScan has a data output on the PC/IF via the supplied USB to serial cable when enabled (for analog systems only). Official 'RadioShack PRO-668 Digital Handheld Scanner Computer Programming System' PRO668 iScan PRO668. It's asinine they won't sign the g-ddamned driver but I even built a new Windows 10 VM again and it doesn't matter if I've got the driver installed or not. Easier to Read Pro 668/PSR 800/EZ-Scan/iScan Manual. I've done that just like I've done it for it back when it was still a Pro-668. Is there something I have to do in order to enable the USB data interface or to mount the µSD (microSD) card or speak to the scanner to haul my config into the Whistler software? Do I have to call or email Whistler about this? The sheet of paper I had in the box when it came back didn't mention anything like this. I was prepared to do the unsigned driver song and dance and nothing was working so I hitched it up to a machine in my household IT rack and `lsusb` doesn't see it no matter what power state it's in and I've tried two USB cables (they are mini USB, the larger small end, not micro USB) and I can't get the scanner to be recognized in Windows 10 on two VMs on two different hypervisors, nor does it show up as a USB device when I plug it into any of the macOS workstations I've got on my desk at home.Ĭan't say I expected a problem like this. I got the scanner back and it has some differences and at least the object browser isn't totally ignorant of DMR anymore so presumably it worked.īut it no longer shows up as a USB device. I sent my Radio Shack 668 p25 scanner to Whistler for the update to listen to DMR. Windows driver installation files needed to use Sentek cables: Suitable for Windows 7, Windows 8/8. ![]()
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |